Saturday, April 10, 2010

Brake and seat alterations

Got the brake light in today so now I get to mount it in the back of the seat pan and adjust the pan to fit the light better.  I did adjust it down some so there wasn't so much space between the tail of the pan and the rear fender.  Had to trim out some around the shock mounts....check out the pictures.











Tuesday, April 6, 2010

Now the fender....

Once the seat is on I can get a good idea where to place the fender so it accommodates the rear brake light and still serves its purpose..... keep the line of mud off my back.









Time to mount the seat.

After hours of debate with myself on how to get the seat on I figured out a way without having to drill new holes in the frame. I would use the existing holes for mounting the faux tank and two back holes, one is for the gas tank and the other is a blank. First I had to trim back the faux tank sides to get the seat pan to line up properly on the frame. Once the seat was lined up properly I could then decide where to drill the seat pan for the bolts. Because these bolts are now serving two purposes I used threaded metric rod and large fender washers to prop up the seat. I could then adjust the seat height by just moving turning the nut to the desired location. Pictures say it all. Oh yah the threaded rod is ground down so that they cant be felt with the seat pad in place.











The final result. I think I still may adjust that seat down farther in the back. We'll see when the rear brake light gets here this week.