Saturday, February 28, 2009

Seized engine

After months of work getting the bike to the point where I could try to run it. I ran into a major road block. On trying to time the bike I noticed the engine would not turn at all. I had never tried it before I started any work as it was a low mileage motor and I was told it had been turned. The gentleman was an honorable person and I believed him... I still do. I believe the problem was created when I clean the motor, though I had taken ever precaution to seal all entry to the cylinders I believe I had a small leak causing rust to build up in the cylinders. Below is the pictures from the left bank (which is relatively clean) and the right (this is where the damage occured). I had spent a good week and a half soaking these cylinders down with Marvel Mystery Oil but could never get them to budge. Here they are.


Sunday, February 1, 2009

Bottom side showing buffed out bowl.

This represents to this point about 3o hours of work and tons of dremel polishing bits.

Old and new. The carb on the right is what the left one looked like when I started. Its still not done yet but its almost there.